Zenith-data-systems MT2000 Bedienungsanleitung PDF herunterladen (Seite 131)

5-43

Upgrades and Options

Carefully pull out on the thumbscrew until the

middle and the top of the front cover are released,

then remove it from the chassis by pulling it

straight up and out of the hinge tabs at the bottom

edge of the cover.

Figure 5-17. Removing Front Plastic Cover

POWER

STATUS

DISK

POWER

RESET

Removing front plastic cover

from media and diskette

drive bays

A Thumbscrew that secures

the front plastic cover to the

front of the chassis

B Four snap-in tabs that

secure the front plastic

cover to the top and middle

of the chassis

C Two frame hinge tabs

Place the frame face down on a soft surface to

prevent marring it.

From the bay where you want to install a drive,

remove the two screws securing the blank panel

tray to the chassis (Figure 5-18).

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 204 205

Keine Kommentare

Zenith-data-systems MT2000 Bedienungsanleitung Seite 131